Shingle Roofing Repair Mistakes to Avoid
Homeowner should be aware of some of the common mistakes made in shingle
roofing repair:
1.
Inadequate or faulty base: A surface repair does not address
problems that arise from damaged decking or improperly
installed underlayment. For best results, roof shingles should be removed so
that an examination of the deck and sheathing can be conducted.
2.
Incorrectly installed shingles: Proper alignment of shingles, especially the
starter course, is critical for a successful repair job. Care should be taken
to offset joints and to be sure shingles lay flat. Ignoring these
considerations may lead to the development of leaks that are hard to detect
until serious damage is done.
3.
Improper or not enough fastening: A good repair job
depends on decking, underlayment and shingles that are all properly attached.
Inadequate fastening allows wind to raise shingles, moisture to work its way
through the layers, and leaks to develop.
4.
Poorly installed flashing: Flashing is needed to channel
moisture away from critical areas. Adequate flashing in valleys and around chimneys, skylights, vents, and satellite dish
installations keep these vulnerable areas from allowing water to penetrate the
roof.
5.
Ignoring manufacturers’ specifications: Failure to follow
guidelines may void manufacturers’ warranties. Proper preparation and
installation ensures a quality repair job and maintains the warranty.
Hiring a reputable, licensed roofing
contractor like Urbach Roofing, Inc. is the best way for homeowners to avoid
the pitfalls of a poor shingle roofing repair. With over 40 years of experience
in roof repair and installation, we make sure the
job is done right, with quality products and following industry-leading
standards.
